Guided NDE LLC

Steel Rope Inspection

Longitudinal guided-wave magnetostrictive inspection

Steel rope inspection uses longitudinal guided waves. The probe arrangement differs from the guided-wave systems used for pipelines and pipe supports.

One-time test

One-time inspection. Large permanent magnets provide the magnetic bias. A ribbon coil wrapped around the steel rope generates longitudinal guided waves and receives echoes from changes along the rope.

Dragline rope inspection

Sergey Vinogradov, Jason Shumka, and Tom Shumka tested dragline pendant ropes using longitudinal guided waves. They compared signals from four draglines and examined how broken wires near rope sockets affected the echoes.

Dragline rope and probe installation beside guided-wave traces at 10, 8, 6, and 5 kHz. A diagram above the traces marks the probe and rope spacers.
Slide 9 compares signals from the same dragline rope at four test frequencies.

Testing of Dragline Ropes Using Magnetostrictive Probes and Longitudinal Guided Waves. 2017 Fall ASNT Conference, Nashville, Tennessee.

SHM of steel ropes

A flexible, low-profile magnetostrictive sensor stays on the rope for repeated measurements. Each sensor element uses one coil for the DC bias and a second coil to transmit and receive guided waves. The design is described in U.S. Patent 9,465,011 B2.

Arrows identify the monitoring probe and the 4-inch wire rope on which it is installed.
Low-profile magnetostrictive sensor mounted on a 4-inch-diameter steel wire rope for structural health monitoring.